Work ESD 10K Automatic Voltage Regulator
It is a voltage regulator able to keep always constant the power supply in 220V
(or 110 V in the additional connector) when the voltage oscillates in a margin
from 140 to 250V ( 220 V input) or 60 to 130 V (110 V input) and connected to
a fix load of 10.000W. The need to keep a stable main voltage, above all for
systems or goods which performing depends on this value, it conserves these
regulators in an appreciated auxiliary device, when we have to supply mixers
effect appliances, etc. The incorporate 2 high brightness displays allow to read
clearly, working conditions, like input, output and main voltage. With the finality
to avoid parasite noise proceeding of the main switch, these units dispose of a
delay in the adjustable switching of 3 or 6 seconds, afterwards it runs in working
normal mode. In the protection section, both devices include protection against a
higher input voltage (255V), overheat and excess of output voltage. In these cases
the unit will switch off, transmitting an acoustic signal and a message in the display.
It disposes of a precise switch in the output voltage which allows to adjust this
parameter from a 1% to 3%.In the front panel, this unit disposes of a 63 A circuit breaker.
In the rear side are placed input/output connection CEE 32 A 3 pole. 1 additional
schucko output for 220 V and another for 110 V.
This unit is cooled by fan.
Power supply: 140V- 250V AC.
Maximum joint load: 10000 VA.
Delay, selectable: 3 or 6 seconds .
Precision of output tension, selectable: 1% - 3%
Excessive temperature of 95 C
High input level
Dimensions: 460x305 x 260 mm